|
…
|
||
|---|---|---|
| .. | ||
| keymaps | ||
| info.json | ||
| readme.md | ||
| rules.mk | ||
3dfoxc
A 3d-printed whitefox with an Elite-C microcontroller.
This is a build of matt3o's "How to Build a Custom Keyboard" guide, except that I have replaced the Teensy with an Elite-C v4. Presumably you could replace it with anything compatible. The USB-C port had to be enlarged with dremel, and the mount for the Teensy was ground off and replaced with everyone's favorite rapid modeling polymer ... hot glue.
- Keyboard Maintainer: david l goodrich
- Hardware Supported:
- 3d-printed whitefox
- Elite-C microcontroller
- Hardware Availability: keebio, 1up, keyhive, splitkb
Wiring
Badly, because I have never done this before. Build pics available upon request, I guess.
Flashing
Make example for this keyboard (after setting up your build environment):
make handwired/3dfoxc:default
Flashing example for this keyboard (use the dfu target for the Elite-C!):
make handwired/3dfoxc:default:dfu
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Bootloader
Enter the bootloader in 3 ways:
- Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
- Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
- Keycode in layout: Press the key mapped to
QK_BOOTif it is available