History

Ryan ebb512db82 Debounce defines cleanup (#19742 ) * Clean up `DEBOUNCE` in config.h, 0-9 * Clean up `DEBOUNCE` in config.h, A * Clean up `DEBOUNCE` in config.h, B * Clean up `DEBOUNCE` in config.h, C * Clean up `DEBOUNCE` in config.h, D * Clean up `DEBOUNCE` in config.h, E * Clean up `DEBOUNCE` in config.h, F * Clean up `DEBOUNCE` in config.h, G * Clean up `DEBOUNCE` in config.h, H * Clean up `DEBOUNCE` in config.h, handwired * Clean up `DEBOUNCE` in config.h, I * Clean up `DEBOUNCE` in config.h, J * Clean up `DEBOUNCE` in config.h, K * Clean up `DEBOUNCE` in config.h, L * Clean up `DEBOUNCE` in config.h, M * Clean up `DEBOUNCE` in config.h, N * Clean up `DEBOUNCE` in config.h, O * Clean up `DEBOUNCE` in config.h, P * Clean up `DEBOUNCE` in config.h, Q * Clean up `DEBOUNCE` in config.h, R * Clean up `DEBOUNCE` in config.h, S * Clean up `DEBOUNCE` in config.h, T * Clean up `DEBOUNCE` in config.h, U * Clean up `DEBOUNCE` in config.h, V * Clean up `DEBOUNCE` in config.h, W * Clean up `DEBOUNCE` in config.h, X * Clean up `DEBOUNCE` in config.h, Y * Clean up `DEBOUNCE` in config.h, Z * Remove default debounce from info.json * Migrate non-default debounce to info.json		2023-02-03 19:19:58 +00:00
..
keymaps	Revert "handwired/3dortho14u: refactor layout data (#16475 )" (#16485 )	2022-03-01 15:48:38 -08:00
rev1	Debounce defines cleanup (#19742 )	2023-02-03 19:19:58 +00:00
rev2	Debounce defines cleanup (#19742 )	2023-02-03 19:19:58 +00:00
readme.md	RESET -> QK_BOOT keyboard readme (#18110 )	2022-08-20 11:34:17 +01:00

readme.md

3dortho14u

A symmetrical 14u wide ortholinear keyboard.

In addition to the 3d printed parts and microcontroller, the following hardware is required:

8 * 12 mm M3 bolt
Either:
- 8 * M3 muts and CA glue OR
- 8 * 3x3 mm threaded insert
Optional:
- USB daughter board

Keyboard Maintainer: xia0
Hardware Supported:
- rev1: Teensy 2.0 (ATmega32u4)
- rev2: Arduino Pro Micro (ATmega32u4)
Hardware Availability: github

Make example for this keyboard (after setting up your build environment):

make 3dortho14u/rev1:default

Flashing example for this keyboard:

make 3dortho14u/rev1:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
Keycode in layout: Press the key mapped to QK_BOOT if it is available