mg/qmk_sweep_skeletyl
1
0
Fork 0
Code Issues Pull requests Projects Releases Wiki Activity
qmk_sweep_skeletyl/keyboards/tkw/grandiceps
History
Joel Challis e9b8929357
Migrate build target markers to keyboard.json - Misc (#23612)
2024-04-25 10:37:44 -07:00
..
keymaps/default Remove legacy keycodes, part 6 (#18740) 2022-10-16 14:14:40 +01:00
rev1 Migrate build target markers to keyboard.json (#23293) 2024-03-30 11:31:50 +00:00
rev2 Migrate build target markers to keyboard.json - Misc (#23612) 2024-04-25 10:37:44 -07:00
config.h WS2812 PWM: prefix for DMA defines (#23111) 2024-03-02 17:16:47 +00:00
halconf.h
info.json Change to development_board (#21695) 2024-04-23 19:47:30 +10:00
mcuconf.h
readme.md RESET -> QK_BOOT keyboard readme (#18110) 2022-08-20 11:34:17 +01:00
rules.mk Migrate build target markers to keyboard.json - TUV (#23514) 2024-04-15 19:19:23 +01:00

readme.md

grandiceps

grandiceps

ARM split keyboard with RGB underglow and encoders.

  • Keyboard Maintainer: vattern
  • Hardware Supported: f411 blackpill
  • Hardware Availability: grandiceps

There are two versions of the Grandiceps. Please use the appropriate firmware for your board.

  • Revision 2 has I2C eeprom and support for a Pimoroni trackball.

Make example for this keyboard (after setting up your build environment):

make tkw/grandiceps:default
make tkw/grandiceps/rev2:default

Flashing example for this keyboard:

make tkw/grandiceps:default:flash
make tkw/grandiceps/rev2:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset buttons: Hold down the BOOT0 button and then briefly press the NRST button on the BlackPill PCB.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available