qmk_sweep_skeletyl/keyboards/durgod/dgk6x

DGK6X = Venus, Hades, Galaxy, etc.

This DGK6X code is shared between the ANSI variants of Venus, Hades and Galaxy keyboards.

• Keyboard Maintainer: J-Sully and dkjer
• Hardware Supported: Durgod Venus, Hades or Galaxy board with STM32F070RBT6
• Hardware Availability: Venus, Hades and Galaxy

Instructions

Build

Instructions for building the Venus, Hades and Galaxy firmware can be found here:

• Venus
• Hades
• Galaxy

Initial Flash

For first Flashing from initial Stock's Firmware

1. Back up original Firmware Image:

• Unplug
• Short Boot0 to Vdd (See below)
• Plug In USB
• Make a Flash Image's Backup in case you wanted to restore the Keyboard to Stock's Image:

  • Using dfu-util:

    dfu-util --list
    dfu-util --alt 0 --dfuse-address 0x08000000 --upload ${OLD_STOCK_BIN}
    

2. Flash the QMK Firmware Image.

• Put board into Bootloader mode, using the same method as when backing up the original Firmware (above)
• Here are a few options for performing the initial Flash:

  • Using QMK Toolbox

  • Using dfu-util:

    dfu-util --alt 0 --dfuse-address 0x08000000 --download ${NEW_QMK_BIN}
    

You can short Boot0 to Vdd by shorting R19 to C30 on the sides closest to the processor, as shown:

• Hades & Venus:

• Galaxy 75

Subsequent Flashing

For repeating Flashing you can use BootMagic:

• BootMagic Lite has been enabled with Assigned "Esc" key
• Unplug USB Cable
• Holding Esc Button
• Plug in USB Cable, Keyboard should be in ST-Bootloader state