qmk_sweep_skeletyl/keyboards/junco

Junco

Junco is a 60% Raspberry Pi Pico powered split keyboard boasting a 4x6 layout with an aggressive columnar stagger. It has 5 "thumb" keys on either side, support for 2-4 rotary encoders, and per-key RGB lighting.

• Keyboard Maintainer: Dane Skalski
• Hardware Supported: Junco PCB, Raspberry Pi Pico
• Hardware Availability: PCB, Case, Parts List

Remember you have to flash both halves of the keyboard for it to work!

Make example for this keyboard (after setting up your build environment):

make junco:default

Flashing example for this keyboard:

# For flashing the left half...
make junco:default:uf2-split-left
# or the qmk cli equivalent:
qmk flash -kb junco --keymap default -bl uf2-split-left

# For flashing the right half...
make junco:default:uf2-split-right
# or the qmk cli equivalent:
qmk flash -kb junco --keymap default -bl uf2-split-right

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset (works after you have flashed once): Hold down the top far corner key while plugging in the keyboard (~ left half, - right half). This will also clear the EEPROM.
• Physical reset button: Hold the BOOT button on the Pico and press the RST button on the Pico, release the the RST button before the BOOT button.
• Keycode in layout: In the default layout, the Bootloader keycode is above home row pinky on the right side's adjust layer.

Once you enter the bootloader, the keyboard will show up as a USB device on your computer, you could drag and drop a firmware file to flash it, but I recommend using the flash commands for the respective side.