qmk_sweep_skeletyl/keyboards/kinesis/stapelberg

kinesis_stapelberg keyboard firmware

This folder contains the firmware customization required to run QMK on the custom controller for the Kinesis Advantage created by Michael Stapelberg. It differs from the alvicstep keyboard in that the existing QMK Kinesis Advantage project uses the existing controller board provided by Kinesis.

The controller board hardware is described here

Mapping the pin assignments was done using the corresponding matrix description provided at this link

This code makes no attempt to drive the four LEDs provided on the controller board.

Building the Hardware

If you want to perform this customization, these parts may be helpful.

Function	Quantity	Vendor	Part Number
13 pin connector for function keys and finger keywells	4	Digi-Key	WM14526-ND
10 pin headers for thumb clusters	4	Digi-Key	609-3250-ND
8 pin cable for thumb clusters	2	Digi-Key	SAM8928-ND
Teensy++ 2.0	1	Digi-Key	1528-1056-ND
2 pin right angle header for reset	1	Digi-Key	3M9467-ND
Reset cables	2	Sparkfun	PRT-09140

The board and connections are shown here

The Teensy mounting detail can be seen here. I used a socket for prototyping.

Since the proper mounting of the Teensy board places the reset button in a tight space, I added a 2-pin header to the reset and ground pins on the edge of the board. Shorting these two pins together will reset the board. I also put female to male header jumper cables on these so they could be accessed outside the enclosure. The exterior cables can be seen here.

Keymaps

Default

To build with the default keymap, run make kinesis/stapelberg while in the QMK directory.

Dvorak

This keymap contains a dvorak implementation as well as media and symbol layers.

Run make kinesis/stapelberg:dvorak while in the QMK directory.